Car, CHANGAN, CHANGAN CS35, 2015, Engine control module (ECM)
Engine - Engine control module (ECM) - 0
Identification
VIN no:
Supplier ECU hardware number: --
System supplier ECU hardware number: --
System supplier ECU software number: --
DTC
Controls
Clear DTC
Data stream
OBD maximum indicated torque: 0.00 %
Actual engine torque: 0.00 %
Target engine torque: 0.00 %
Engine temperature: -48.00 °C
Engine speed: 0.00 rpm
Engine running time after startup: 0.00 sec
Vehicle speed: 0.00 km/h
Barometric pressure: 0.00 bar
Battery voltage: 0.00 V
Throttle opening: 0.00 % DK
Intake air temperature: -48.00 °C
Ambient temperature: -48.00 °C
Accelerator pedal position: 0.00 %
Fuel volume flow: 0.00 L/s
Manifold exhaust temperature: -273.15 °C
Engine load: 0.00 %
Air flow: 0 kg/h
O2 sensor downstream catalyst: -0.20 V
Charging efficiency (relative charge air volume): 0.00 %
Torque constant: 0
Actual torque at response of torque comparison in the function monitoring: 0.00 %
Alternative model for engine temperature signal when error occurred: -48.00 °C
Desired throttle opening: 0.00 %
Exhaust gas temperature sensor 2, bank 1: -50 °C
Coolant temperature (unfiltered value): -48.00 °C
Calculated torque: 0.00 %
Ignition advance angle: 0.00 °
Secondary air charging model mass air flow correction factor: 0.00
Throttle position sensor 1: 0.00 % DK
Throttle position sensor 2: 0.00 % DK
PID control volume of controlled throttle: 0.00 %
8-digits precision variants for limp opening: 0.00 % DK
ETC primary signal voltage under limp home mode: 0.00 V
Accelerator pedal opening indicated by sensor voltage 1: 0.00 V
Longitudinal acceleration: 0.00 m/s²
Intake manifold pressure: 0.00 bar
Number of clutch operations detected: 0
Intake air temperature (unfiltered value): -48.00 °C
Vehicle speed (unfiltered value): 0.00 km/h
Sampled battery voltage: 0.00 V
Oil temperature sensor: -273.15 °C
Lambda closed loop correction factor: 0.00
Air mixture self-learning multiplicative correction factor: 0.00
Throttle position sensor 1: 0.00 V
Throttle position sensor 2: 0.00 V
Air mixture self-learning additive correction: 0.00
Accelerator pedal position sensor 1: 0.00 V
Accelerator pedal position sensor 2: 0.00 V
2 times of the voltage of accelerator pedal potentiometer 2: 0.00 V
O2 sensor 2, bank 1 internal resistance: 0 Ohm
Exhaust gas temperature sensor 1, bank 1: -273.15 °C
Fuel injection pulse width: 0.00 ms
Target speed of static idle: 0 rpm
Retard ignition knock control at cylinder 1: 0.00 °
Retard ignition knock control at cylinder 2: 0.00 °
Retard ignition knock control at cylinder 3: 0.00 °
Retard ignition knock control at cylinder 4: 0.00 °
Knock signal cylinder 1: 0.00 V
Knock signal cylinder 2: 0.00 V
Knock signal cylinder 3: 0.00 V
Knock signal cylinder 4: 0.00 V
Coolant temperature at engine start: -48.00 °C
Standard air charging volume calculated by canister control: 0.00 kg/h
Target ignition angle: 0.00 °
Total number of misfire: 0
Misfire cylinder 1: 0
Misfire cylinder 2: 0
Misfire cylinder 3: 0
Misfire cylinder 4: 0
Lambda forced regulation cycle: 0
Misfire range, minimum load: 0 rpm
Misfire range, maximum load: 0 rpm
Torque correction for idle speed control: 0.00 %
Intake manifold pressure sensor: 0.00 V
O2 sensor 1, bank 1: 0.00 V
O2 sensor 2, bank 1: 0.00 V
IUMPR information
General denominator counter: 0
Ignition counter: 0
Catalytic converter numerator: 0
Catalytic converter denominator: 0
O2 sensor 1 aging numerator: 0
O2 sensor 1 aging denominator: 0
O2 sensor 2 heating diagnostic numerator: 0
O2 sensor 2 heating diagnostic denominator: 0
Coolant temperature numerator: 0
Coolant temperature denominator: 0
Intake air temperature numerator: 0
Intake air temperature denominator: 0
Intake air pressure numerator: 0
Intake air pressure denominator: 0
Vehicle speed numerator: 0
Vehicle speed denominator: 0
Idle speed numerator: 0
Idle speed denominator: 0
Throttle position diagnosis numerator: 0
Throttle position diagnosis denominator: 0
Throttle range diagnosis numerator: 0
Throttle range diagnosis denominator: 0
Camshaft relative position 1 numerator: 0
Camshaft relative position 1 denominator: 0
Camshaft relative position 2 numerator: 0
Camshaft relative position 2 denominator: 0
Overboost numerator: 0
Overboost denominator: 0
Boost pressure leakage diagnostic numerator: 0
Boost pressure leakage diagnostic denominator: 0
Pressure relief valve numerator: 0
Pressure relief valve denominator: 0
Mass air flow sensor 1 numerator: 0
Mass air flow sensor 1 denominator: 0
Mass air flow sensor 2 numerator: 0
Mass air flow sensor 2 denominator: 0
Ambient temperature numerator: 0
Ambient temperature denominator: 0
Reason for can not stop: complete vehicle related conditions not met
Front hood opened: --
Driver absent: --
Low battery: --
Insufficient brake fluid: --
A/C compressor target status: --
Starter overheated: --
Neutral switch and lower clutch switch diagnosis unfinished: --
Upper clutch switch diagnosis unfinished: --
Engine doesn't meet the shutdown conditions: --
TCU (Transmission Control Unit) prohibited auto stop [only for vehicle with A/T]: --
BCM (Body Control Module) prohibit auto stop [only for BCM involved in the start/stop system]: --
Altitude too high: --
Reason for can not stop: engine related conditions not met
Canister high load: --
Torque loss adaptation unfinished: --
Driving cycle conditions not met: --
Canister valve diagnosis not finished: --
Turbocharging system does not meet the shutdown conditions [only for turbocharged engine]: --
Engine coolant temperature out of range: --
Catalyst temperature not high enough: --
Mixture adaptation unfinished: --
Catalyst heating stage: --
Throttle adaptation unfinished: --
Reason for can not stop: engine related fault
Throttle body faulty: --
Coolant temperature sensor fault: --
Engine startup time too long: --
Phase sensor error: --
Engine synchronization signal faulty: --
Generator feedback PWM signal fault: --
VVT (Variable Valve Timing) fault: --
Engine speed sensor faulty: --
Engine forbid condition - main load sensor error: --
Starting time record
Number of timeout start times: 0 Count
1st group start time: 0.00 sec
2nd group start time: -- sec
3rd group start time: -- sec
4th group start time: -- sec
5th group start time: -- sec
Maximum speed at start of 1st group: -- rpm
Maximum speed at start of 2nd group: -- rpm
Maximum speed at start of 3rd group: -- rpm
Maximum speed at start of 4th group: -- rpm
Maximum speed at start of 5th group: -- rpm
Actuators test
Controls
Fuel pump relay
Fan1
Fan2
Engine fault lamp (with low)
Service Vehicle Soon (SVS) telltale
Utility
Controls
Edit VIN