Car, MITSUBISHI, PHEV (GG), 2018, GG2W, XDHHZR8, OBC

Identifier: 00 01

ECU origin: 04

Supplier number: 85

ECU ID: 00

Diagnostic version: 01

Hardware version number: 86 00

Software version: 86 00 04

Part number: 8638A037

Software number: 8637A69600

VIN no (original): --

Class: --

Model: --

Type: --

Model year: --

VIN no: --

Calibration ID: --

Calibration verification number (CVN): --

U1120: C-CAN bus line low input

Clear DTC

Current charge time: 0 min

Accumulated CHG fail stop count: 23 times

DCDC - accumulated active count: 13145 times

DCDC - accumulated active time: 508885 min

DCDC - current active time: 7 min

DCDC - accumulated fail stop count: 0 times

Accumulated CHG count for 100 V: 28 times

Accumulated CHG count for 200 V: 2944 times

Accumulated CHG time for 100 V: 0 min

Accumulated CHG time for 200 V: 300098 min

Voltage target value: 0.0 V

Current target value: 0.0 A

Power supply voltage: 14.5 V

PFC - output voltage: 194 V

Pilot signal - duty ratio: 0 %

PFC - temperature: 12 °C

Inverter temperature 1: 10 °C

Inverter temperature 2: 11 °C

Inside temperature: 14 °C

Power supply voltage (CAN): 14.5 V

On board CHG permit (CAN) flag: Off

EEPROM - write status: Complete

Motor/Inverter - coolant temperature: 9 °C

Charge start-up req. signal (HW): Lo

S2 switch: Off

Charge flag: Off

Charge start-up req. signal (CAN): Lo

Abnormal stop flag: Off

Cooling request flag: Off

Control power supply req. flag: On

Limit history (input voltage) - output: No record

PFC - start-up flag: Off

Input current 0 point check: Not accept

Limit history (temp trigger) - output: No record

Control mode: Idle

Limit flag - output: Off

Current input voltage type: No input

Limit judge (temp) - output: Off

Limit judge (input voltage) - output: Off

Input voltage: 0 V

Input current: 0.0 A

Output voltage: 320 V

Current - output: 0.1 A

DCDC - power supply voltage: 14.5 V

DCDC - inverter temperature 1: 19 °C

DCDC - rectification temperature: 13 °C

DCDC - inverter temperature 2: 27 °C

DCDC - power supply voltage (CAN): 14.5 V

DCDC motor/inverter coolant temperature: 9 °C

DCDC - drive permission flag: On

DCDC - drive flag: On

DCDC - fail flag: Off

DCDC - output volt target value: 14.70 V

DCDC - input voltage: 322 V

DCDC - input current: 1.2 A

DCDC - output voltage (S terminal): 14.7 V

DCDC - output voltage (B terminal): 14.8 V

DCDC - output current: 28 A